Recent content by Dex64

Ok ya I don’t have that issue. It holds perfectly

I don’t care about the parts to be honest, if I can get this thing to work then anything I can replace with a new part will be replaced regardless if it works fine. If I can’t get it to work with every new part I can replace then I’ll j toss it in the bin. I’m about $50 deep into this thing so...

What do you mean by “leak down”. I remember my buddies air compressor would automatically shut off and then you’d hear air escaping from somewhere. Almost as a discharge. His is a one stage oil air compressor. It was a very quite sound of air escaping.. if that’s what you’re talking about then I...

I’m just new to air compressors. Never owned one so never needed to maintain one. I’m just building a truck so I’m looking for the right guidance on this and get everyone’s opinion. I’m not arguing with anyone or saying anyone is wrong, I’m just using what I think is common sense and saying if...

Just put new gaskets so they should be fine hopefully

Yes I already ordered a new one via part number. I would clean it but idc what it takes to make this compressor run

Oil less air compressor, not sure if they have reed valves. When replacing the piston, sleeves and what not, I did not notice any reed valves

I’ll be doing it. Where should I spray and not spray? Kind of like the general area? Exactly what would you want me to spray.

If there was a leak like that wouldn’t I hear air escaping? Also this is a 20 year old compressor lol so I’m think worst case scenario the motor is clapped out of its mind.

It holds pressure yes

It does not get that hot. I can touch and keep my fingers there no problem. It has 2 pipes by the way one leasing into the motor or something and then one copper tube leading to the pressure switch where the wires are hooked up. The one going to the motor is a silver color and also doesn’t get hot.

I’ll order one and try

Yes that copper tube that runs to the on and off switch contraption module thing. It does not get burning hot. I’m thinking it may be clogged. Should the tank be drained of air when taking this off?

Hello. So I got this oil free craftsman model #919165610 air compressor and it wouldn’t build over 90 psi… so I went ahead and changed the cylinders and rings and anything associated to that with new items. It builds over 90 psi now (I let it run until it got to 110ish and then turned it off...