Recent content by DezRanger

Well my Lowes wouldn't price match, still showing a stocked item and wouldn't price match out of state. :( Sent from my SCH-I545 using Tapatalk 2

Where are these located inside the store? Sent from my SCH-I545 using Tapatalk 2

The small key chain knife was on a end cap in hand tools section. The bigger one was down the aisle with rolls of insulation and roofing just hanging down one of the columns, the mailboxes were on same aisle and the yellow tag caught my eye and figured since it was such a steep discount I...

Larger folding knife actually rang up $2.99 Sent from my SCH-I545 using Tapatalk 2

Lowes in Mesa, AZ on US60/Ellsworth had several Sent from my SCH-I545 using Tapatalk 2

Just a update, ended up buying a braided stainless line off eBay. Sent from my SCH-I545 using Tapatalk 2

Zkling: I guess I could look into having a line made locally, I was just looking online at braided compressor pump discharge lines and shortest I've seen is 12" which I'd run into issues (bend radius) with having such a short distance. Sent from my SCH-I545 using Tapatalk 2

Well thats the thing, if i loop the hose with the current setup, turning the 45* to the left towards the motor more is something like a 3" radius and McMaster carr sells a 4 3/8" radius on a 1/2" line, tightest I can find, unless im over thinking this

So I'm building a frankenstein compressor more or less and need help plumbing my new pump to my check valve in the tank. My original plan was to use a braided steel hose from the pump an run it around under the motor platform and connect it to the check valve into a 90*. Well the 90* was...

thanks for the replies. the pump specs are.. 3hp Rated Air Pressure 145 PSI Maximum Speed 1050 RPM Air Delivery @ 1050 RPM 11 SCFM @ 40 PSI 10 SCFM @ 90 PSI Pump Pulley 12-1/2" diameter with single V-groove 5hp Rated Air Pressure 145 PSI Maximum Speed 1050 RPM Air Delivery @ 1050 RPM 17.3 SCFM...

If anyone read this thread http://www.garagejournal.com/forum/showthread.php?t=201317 I ended up getting it for free, long story short wired up motor and it kicked on no problems...so i spent $70 buying new pressure switch, belt, pulley and some wire...hook it all up and pump makes terrible...

Local Lowes only marked down Knipex / Channel Lock a few dollars but did have 14/16/18 gauge wire rolls marked down to $2.31 Sent from my Galaxy Nexus using Tapatalk 2

Good point, I'll look into it. Sent from my Galaxy Nexus using Tapatalk 2

Well got it for free! Ran that route again and got talking to the guy and he said if I just wanted it I could have it. He also has a box of parts with old motor that he said is bad. (hopefully just a capacitor or something) Just got it home and noticed it had about what seemed like a gallon of...

Trying to program travel on my brand new opener. Following directions and I can only get it to move about 6-8" in either direction vs. the whole length of the track...I took a quick vid on my phone. (its :58 long) -yes the sensors are lined up (both lights are on) -I even unhooked trolley from...