Recent content by dieselgarage

Another option. http://www.menards.com/main/lighting-fans/ceiling-fans/industrial-fans/hunter-96-in-industrial-ceiling-fan/p-1766562-c-7486.htm

Would this be a good thing or bad?

Thanks :thumbup:

Scotty, If you remember I have about 4000 sq that I want to seal with your HD-6500. I had the finishers burn my floor black. So I understand I have to etch it to give the HD-6500 something to bit on to. So my questions are: 1) Do you have a product that is comparable to this for etching...

One more thought but it's hard on the roller. Let the ends overlap and run through the roller and then cut/trim the excess of for fit up.

Do you have a three roll roller, or a four? Both still have the same issue just the four roll makes it less. We roll lots of heavy rings. We do it a few different ways when it comes to the flat issue. I will bump bent the ends prior to rolling. Or run the ends in and out of our sheet roller...

I have a spot like that that appears right in the middle of by basement floor after extend rains. The only thing I can figure is the water is coming up through the floor. Just another idea.

I like your taste in color.

100% agree with you. Why not be ready for the year you may not want or can not run the heat. Little planning can go along way.

Look up heated water hyd used for trailer homes. That is what I used. I would post a link for you but I don't know how do it from my phone.

I think about the little floor contact points under those dolly wheels. Must be a hell of a concentrated load. Or do they retract and the frame is in full contact with the floor?

If you end up needing help with the welding let me know looks like we are close by. I have about 30 guys that weld nothing but stainless.

I like the siding on your house what do they call it?

I went with Hass doors. 2-12X12 and 1-14x14 3" thick door insulated not cheap but a very good door