Recent content by djamesm

Ok, sorry guys. I am just trying to get this off the ground. I really do have good intentions. I moved to Texas to take care of our wounded warriors as their doctor, and at the same time to interface with foundries. I initially, when I was laboring under the fantasy of manufacturing in the USA...

Yup, you are right. I want to apologize to anyone I offended. Let's talk about the tool. It is a very compact, flex head open end ratchet with a 30 degree operating envelope. You can tighten the flex head with the torx screw to the point it locks. If it wears with use, just tighten a little...

How's this for a late reply. I am the inventor and a member of the struggling American family. And it is hardly a gimmick. You have no idea. I am an MD, and this is way harder than med school. Do you know what I would have to charge for a set of tools made in America? About 160 bucks for a 7...

I do like the swing arm box ratchet design, but there is no way it will get in the tight spots the Ratchet Tech will. You have to swing open the long arm, apply it to the fastener, close the arm (if you have the room) and ratchet. And it is also a 30 degree throw, so you don't gain in that...

What he meant was it is a flank drive, and never smashes directly on the point of the corner like a conventional open end can.

Ratchet Tech will go as small as 3/8.