Recent content by dkhoe

Hello Christine and everyone following this thread, we've been occupied with moving furniture, equipment, and people into this space, working against a month-end deadline. Not much time lately to think or write about our "little" epoxy problem. I need to clarify a couple of misconceptions...

Thanks for everyone's comments. I will let Christine and the other folks at Epoxy-Coat come up with what they think the problem was. Hope that I won't need to section and send a piece of my floor to figure it out :). To those who asked about roller covers, we used some of the covers that were...

Took a much closer look at the bumps on the part of the floor where we made the changes, cured now to the point I can walk on it. Yes there is a difference - the bumps are more sparse and they're also smaller, maybe by a factor of 2. The total space is about 3000 sq ft, divided into 2...

After much preparation and cleaning, we finally laid down the epoxy this weekend on our small industrial space. It was easy to spread out and roll out. We did not use anti-slip material or flakes because we wanted a completely smooth and glossy finish. However, after the final roll of each...

Thank you for all your suggestions.... much appreciated! :thumbup: Since the epoxy has held up for 5 yrs except for the isolated areas, I was hoping that I would NOT need to grind it all off. Yes I know, it would be at my risk of future problems. What I didn't mention in my first post is...

Has anyone laid epoxy over a previously epoxied floor? What preparation steps would you guys recommend? Just light sanding/scuffing or should I try to remove the old coating completely? The floor was coated about 5 yrs ago, and for the most part it's holding up pretty well. Some small...