Recent content by donny

plans look good..involved..here is what I did as far as a rod holder..and tank mounting...

simple was the key for me...got the motor back from the machine shop..car not ready...very simple, rusty, but functional stand...larger stand in photo is for motor and ******..sbc,bbc..muncie or T-350 trannys...smaller stand is just for motor..

I used some angle brackets I had and some square tubing to set the wheels on....gets them stored up out of the way..

nada here

No plans...bought an armload of tubing, hung the motor/bh from the picker and went at it...the base is 4 feet x 27 1/2 inches.the base rectangle is made out of 1 1/2 square tubing..the wheels are HF deals..330lbs rating..I would buy better wheels if building another but these work. You can see...

another new guy finding out about this great and interesting site. I keep seeing it mentioned on the Hamb...retired from the RR , live in Southern Arizona...love cars and TOOLS....thanks...Donny

I just completed this 'run stand'...it is all 16 gauge tubing except for the obvious areas that allows the deal to be clamped together...1 1/2 strap..some 1 inch pipe and some 1/2 or 3/8's was used for the upper/lower mount area..used a variety of different tubing sizes..seems to work fine...D