Recent content by dplank43

Bought a cart off cl for 30 bucks its a blue point but the bottom drawers missing the slides snappy dealer says hes gonna get me a set cleared out a ton of drawer space any suggestions for organizin it or addons to it

thanks :beer: and im down in clearwater

i do more trannies than anything but i have a hole cut in my cart with a piece of ply wood over when i dont have a ****** in it i try to keep the heavy stuff off the box it usually ends up with valve bodies and clutch packs on it but the last carb i did was on an 85 f150 with a 4.9 about 2 years...

Hell i wish i didnt have the bills but i moved out the day after i graduated high school dad was a druggie mom was never home i left and worked at mcdonalds and did side work til i turned 18 on my birthday got a job at a dealer but i really appreciate the input and i do not want to go into debt...

this is the stuff i have borrowed 2 or more times in the past few weeks valve spring compressor 3/8 and 1/2 torque wrenches flare nut wrenches torx and hex bit sockets bearing driver slide hammer pulley pullers air hammer caliper compressor compression tester coolant pressure tester...

And unfortunately a top box is a no go, my box doubles as a work bench unfortunately.

Thanks for the quick replies. But where are the protos sold at? And i really dislike the US General box for my use, but I wanted to have good tools before a more expensive box. But about the US general box i really just don't care for it. The slides are dragging bad with the weight and they've...

Hey, new to the forum here. Been under a hood since i could walk pretty decent at what I do. been in a dealership tech position since my 18th birthday. Turn 20 in August. I am still an apprentice tech, and i need a little advice on my tools. I have a 44 inch US general box that i paid 100 bucks...

Hey, new to the forum here. Been under a hood since i could walk pretty decent at what I do. been in a dealership tech position since my 18th birthday. Turn 20 in August. I am still an apprentice tech, and i need a little advice on my tools. I have a 44 inch US general box that i paid 100 bucks...