Recent content by DrewFSD

This 100% Rust-Oleum makes a self etching primer or any self etching primer.

I've done a few buildings with pro snap, it's definitely more labor intensive than pro rib, but in an interior it probably wouldn't matter so much. The only thing about it is that I've found it's actually a bit more than 16" which is a bit annoying. 1/2 osb would probably be best under it, but...

Diamond grinding wheel across the whole surface, it was pretty spalled in some places, so I used the Rust-Oleum filler on that. I do wish I would have used more fillers on the areas that weren't as badly spalled as the worse parts, just because those areas collect dirt.

So I ended up doing it in 2020 and it has held up really well. I've drag floor jacks across it and no failures so far. I wouldn't hesitate to do it again.

Nothing, I'll be working more hours, no time to be at home in the garage.

Except the velcro

Lol $10 of sheetrock scrap and a small tub of mud can fix any damage to the "precious" sheetrock. If you're putting that many holes in sheetrock accidentally I think you have other problems.

I'd like to think that too, but there's at least a few idiots on Facebook thinking that barrel will make a good smoker, but don't need the oil or have a way to dispose of it. I try not to underestimate people's stupidity anymore.

I have gloss white exterior on the ceiling and then just a good white primer for the walls, the white primer is cheap and i just roll more on once it starts to get a little dingy.

https://www.google.com/shopping/product/6085692335645010551?q=Bluetooth+to+rca&prds=epd:10389162899440934317,prmr:3,tpim:CMDkrsOTjqrBORC9tI35p6vF93QYsKL1CyIDVVNEKPC8wvUFMPa62Ds,pdprs:5,cs:1&utm_medium=tu_cu&utm_source=tu&utm_campaign=125181302&gclid=CjwKCAjw4pT1BRBUEiwAm5QuR6Jf80J0UbqH8PzG3bEYF9D...

Well after looking for car parts that I cannot seem to find, I have decided I need to put everything into stack able clear storage bins. Anyone do something like this and have a storage wall or some other ideas on bins that work best? I've been thinking just the 72 qt storage bins.

They're usually tied into the sump system so if it does rain hard enough it would just go to the pit. Plus you want to vent the radioactive gas away from people not down back at them

I'm looking for extra wide white vinyl fabric to upholster a project, but am having trouble finding anything wider than a 54 in width. I'm needing 62 in wide and wanted to know if anyone knew a good place to buy it.

Did you clean it out again for him?

Spend $10 and keep on making the same labels. https://www.target.com/p/label-maker-organizer-xpress-pro-black-dymo/-/A-53006275