Recent content by dsimonl

Those sure look sweet !!!:bounce:

I have done just that by mistake with my Fluke 87mkiV. The internal fuse blew. No big deal, just replaced it.

I've purchased from them a few times. Always quick shipping. They always get me back by sending enticing discount codes :)

I double checked. No screws or adjustment knobs. Is it possible that these older air tools require more than 5-6 cfm and thats why I have no torque? Will I have the same problem with the HF Earthquake?

No. There are no screws that I noticed. I took the ratcheting mechanism out and cleaned it thinking it was binding, but it was fine. Too bad, it looks like a nice tool.

I was heading down to HF to pick up one of the 3/8 Earthquake impact ratchets. On the way I stopped at a pawn shop and was talked into a 3/8 Blue Point ratchet. The HF wa $57 with coupon, this was $50. I took it home and tried it. It ratchets forwards and backwards fine, but I can stop it...

I'll disagree. I bought the griplatch after closely comparing it with the HF. It was made in Mexico, btw. Both can be found on deep discount, so make sure to compare apples w/apples.

1st post. Just ordered 3!!! Thanks for the tip.