Recent content by DUK

Looks like my CHI insulated double panel 14'wx9't is starting to buckle at the bottom corners. I'm thinking this is from having the rails at an angle matching my roof pitch. And with the Liftmaster 8500 opener putting load on the pins while opening and sitting at the angle when open. Anyone...

Sanddan- Going to do both, build and rebuild. Hunter1151- Yep it is an '80 Margay Xpert. I had one back in the day and have taken up vintage karting. Of course, the old frames are breaking and bending easily from fatigue so I am going to repop them.

What the table above is being used for...

Here is what I did finally. The screw lifts the table.

To answer the question on the retractable casters, here is what I did. Also here is how I attached the top. I weldedthe nuts into the rails and ground smooth.

Started on the fixtures fro my go kart jig...

Actually you would be surprised how much the transverse connections do.

I started on a gokart fixture table today. Still have to finish the retractable casters.

It can be, but it weighs ~400lbs. I made provisions to be able to pick it up with the forks on my tractor. I don't expect to have to remove it, as it is my second lift and is only used to store the 911 or the boxster.

One I started on today, have to finish the retractable casters.

Here is what I did. Kinda best of both worlds... http://www.garagejournal.com/forum/showthread.php?t=275287

Here is 29 gauge (.0172) from Lowes and my rafters are 24" on center. I like it but would actually think about 24 gauge to help with some of the sagging.

2x3x.083

http://ddmgaragedoors.com/index.php Call Dan, he will answer all your questions and sell you the right stuff.

No problem guys. Steal away. I am here to help if you have any questions.