E46 Tony's latest activity
-
EI won't get into a debate, but you are going to need to strip that to bare metal again and then treat it with something like Metal Prep...
-
EE46 Tony replied to the thread Show your new tool arrivals.I will when I'm ready to strip and paint the whole shell, I just wanted to stop the rust and get some protection on there for now until...
-
EE46 Tony replied to the thread Show your new tool arrivals.I picked up the surface conditioning tool from HF to clean up the roof of my project Mustang and get some rattle can primer on it for...
-
-
EE46 Tony reacted to tarbellb's post in the thread Insanely bad customer service experience from Matco with
Haha.
This is a usage and failure warranty not a cosmetics issue -
EE46 Tony reacted to cvcman's post in the thread Any info on the Daytona 6 ton jack stands with Haha.
I’m probably fatter than you 😂 I have a set now that I’ve had for a few years Wonder if the new ones are the same
-
EE46 Tony replied to the thread Any info on the Daytona 6 ton jack stands.I didn't think to mention that but yes. There are also two versions of the Daytona 3 ton but the better version seems to be most...
-
EE46 Tony reacted to Kaervak's post in the thread Any info on the Daytona 6 ton jack stands with Like.
There are two versions with the same SKU. Buy the ones with 24" maximum height, they have better build quality.
-
EE46 Tony replied to the thread Any info on the Daytona 6 ton jack stands.My project Mustang is on a set, I have no complaints. There is plenty of room to work without extending them.
-
