Recent content by Ecosta777

SOLD

$20 shipped

Bridgeport No 30 Hacksaw. Really dont know anything about it and have too many saws! $30 shipping included. Paypal, Venmo, Check accepted

DO NOT put a shaft through the spindle and lift it that way. Move the carriage and tailstock as far as you can to the end of the bed to help offset the headstock weight. Choker or loop the straps around the bed at each end taking care they are not pressing on the leadscrew, do not use pipes...

Bump

Hope this is ok to post here, not having luck on CL. 1965 BSA Lightning 650. Has had head bored / new cylinders. I did new clutch plates, coils, cables, and carbs. Also has new mufflers, and any chrome was re-chromed. Has been sitting a few years but was running when stored. Stored in...

Yes, thought about doing that with LP Smart side sheets as last ditch

LP smart side has the product I am looking for, but no one carries it? Contacted them directly and have not heard back from them yet.... Hardie does not supply the width I need. Emails out to both companies, thank you. Have not heard back yet though....

Not for the garage but on my house. The house was built in the 70's and uses 12" Masonite / hardboard / smooth lap siding. Dimensions are 5/16" x 12" x usually 16' long. We're doing some renovations and I'll need a few pieces for that. I sourced some before from a local lumber yard that randomly...

Joe is the son of a family friend and was a couple years behind me in school, I'm not sure if he does that type of thing or if he does more residential, but he's a great guy who just started his own business. Doesn't appear to have a website yet, can't seem to get the Google link to work. But...

Maybe the sister company to Square D? :bounce:

Here's my stack, finally got it all set up. I got everything over the last few years. I had dreams of restoring everything before using it, so I had it set aside in the basement, but my wife and I both wanted the space in the basement for other things, so I decided to move it into the shop and...

Recently finished this for my Clausing 5914 lathe. I only really wanted the For / Rev sticker. I ended up adding the power on / off procedure sticker because when drilling the hole for the power switch, the hole saw jumped and scratched the box, and I needed to cover it up. Teco L510 3HP, using...

Picked this Milwaukee grinder up a few months ago. Actually made by Kingston-Conley. I wanted this style in particular because of the heavy duty tool rests.

I just replaced them with oilite bushings in a motor I did recently