ehcsrop's latest activity

I have a rolling gate 8' wide by about 6' H, hence no diagonal brace. The is one centered upright. I found that 2 x 2 square tubing is...

@Shiftless, totally agree. Yet outdoor low voltage wire rated for burial is costly, the only disadvantage I can see to not have a LV...

Turn it almost 90º.

I'd put the pipe in the foundation anyway. You don't have to use it but you can't add it later

Or plan the yield. At least run through the house and make all the long cuts first. But I've seen and done worse. At least I can say I...

Nope. Better pics produce better comments. It didn't look like much breakage anyway. Just thoughts, that's all. Not my problem how it...

Something is broken on the cradle. That pawl holding the keyway in the ball was not very deep to start with. I submit that the...

Isn't this Garage Journal Electrical College? IF I log 4000 hours here do I qualify for a residential cert in CA (and similar...

Can't buy good stripper in CA. @Gutman, I'm not sure what degree of destruction your recommendations are but this is like stripping...

Noticed that. :p

Thanks to both of you. I'm not sure that link was up this morning, but I could have missed it. That's the same brand I was looking at...

I did a search being a bit of a newbie around here and did not see the tool I'm talking about but it may go by a different name. Some...

I did find there is a Rover Bit by Bad Dog Tools (no affiliation whatsoever) that claims to be able to drill drifting off center to help...