Recent content by enginenine

PM sent

I'm missing a 19mm deep well impact. I misplaced it somewhere more than a month ago and had to go buy another one because it gets used a lot on imports.

Looks like you could use it run the corrugated ends of metal ductwork.

I've been looking for some but have not found any quality ones under that price also.

Tool Envy!!!!

I wonder what it cost to drive that 1 ton dodge over there?

Re: what did you do in your garage today? Changed aerator pump in bass tracker live well, Fixed a tiller and finished reassembling the interior of a 70 cutlass so I can get the new windshield installed on Tuesday.

Circular saw blade sharpening jig? Can be pivoted for different tooth angles and has a travel stop.

After further research it appears that Devoe is now owned by International Marine Coatings so ago may no be an issue as the new cans only say Devoe on them.

Is it Ameron/Devoe or just Devoe? I ask because Devoe was bought out by Ameron out of Little Rock, AR over 10yrs ago. If it says only Devoe it could have some age on it. I worked for a marine supply house and we sold thousands of gallons of Devoe a week. Their marine epoxy's were Bar-rust...

I work out of a downtown firestation. I have heard so many sob stories that I don't believe any of them.

Or a raw water circulating pump for a boat with an inboard

I have 3-400w Metal Halide high bays down the center with 4-T12 fluorescents down both sides where the wall meets the roof, angled slightly toward the center. All on separate switches.

Me also.