Recent content by EpicCowlick

I have a few ATV's and a motorcycle sitting on a kickstand. I just checked and there is zero deflection or dent in the tiles. The tires on the Polaris RZR started to leave yellow marks so I just place an extra tile under those tiles when I park it. All the other ATV's leave no marks. Go figure.

Thanks everyone for the comments and the concern for my health... :eyecrazy: I was just lazy and know it's best to use proper equipment. I didn't use the mask for the grinding part but I did put on proper gear right after I started the paint. I was just trying to get the gun setup before I...

Sorry for the slow response. Been traveling. Floor prep was pretty easy, no degreasing. I did fill the joints with some thinset in the widest gaps but I left the narrowest gaps alone. So far so good. The video showed me pulling up and replacing some tiles due to pulling the car onto the floor...

Sorry guys, it was Peter Gabriel's fault. You won't be able to listen to Sledge Hammer on this version. It should be fixed now.

Thanks. Your floor looks great also. I was just going for a little more subtle look. But then again, I don't have Porche's in the garage either... :bowdown:

I've since added new cabinets on the walls to close everything up. No more anything hanging on nails on the walls! I also put commercial casters on the fridge and freezer and an open rack so they are really easy pull out and clean under. The new rule in my garage is, it has to have wheels if...

Thanks. Yeah, it was a sorta fun project. The thing I've learned about VCT is that it can move. You saw the part where I had to lift and re-set some tiles. The floor has been down for a month now but I'm still afraid to park the car & truck directly on the tiles. It's the front tires that cause...

I just finished the floor in my garage. Here's my experience:

Half of my garage slopes the wrong way as well. It's not a problem other than the snow and ice from the cars melts and collects in certain low spots. Rather than re-layering the entire floor, I just cut some 3 inch drains at those places and the water runs right under the slab. It's not much...