Recent content by EvellSnoats

Thinking the same. Sent from my SM-G955U using The Garage Journal mobile app

Garage floor is below the grade of the connected apartment where the waste pipe runs from. Sent from my SM-G955U using The Garage Journal mobile app

I could but it would involve a choice between getting into the wall and looking like a kludge. Sent from my SM-G955U using The Garage Journal mobile app

I want to put a utility sink in my garage that is really a part of an old carriage house. The 4" waste pipe is about 30" off of the garage floor, so I need a pump to get the water up to the connection to the drain. The utility sink is actually sitting right by the drain line in a corner, so the...

I have a place in Paris, TN and live in Oxford, MS so Jackson is about the midway point. I go to a bunch of auctions in the area and I can tell you that stuff that looks like absolute trash goes for good money. I usually go looking for old tool boxes and always resent having to wait around while...

It was the centrifugal switch. Piece of plastic broke and buggered up the switch. Green Electric in Memphis fixed it and replaced the cap for $140. I am hooking it back up tomorrow. Thanks again for the input.

Thanks for the tip on the centrifugal switch. Since I have to take the motor off anyway I will crack open the back and see if maybe that is it.

Yeah, trying to do that is tough in the hinterlands. I have a lead on a repair guy here in town, otherwise looks like I have to haul the motor up to Memphis, which I would hope would have one. I just wanted to make sure it was the motor and not the pressure switch causing the problem...

I puled both capacitors to make sure the wiring laid out in the right position. So I hooked up the capacitor I got from my local guys which was too large to fit under the cover. The compressor seems to run fine, no smoke. I am scared to run it for very long that way. Hook up the replacement...

Baldor Relinacer 35Q760R305G1 Thanks for any help

I have a NAPA VAT82356 compressor (five horse two stage). Had it about a year when I tried to start it one morning and it would just hum. I tried to see if something was wrong with the wiring and switched up the load / to motor wiring on the pressure switch as it looked backwards. Stupid I know...