Recent content by evilcheese

Can the GLLUSA GL07103-3M(5000K) bulbs (bought from ProLighting) be used in single ended mode? The reason I ask is, I received a batch and each bulb has a sticker on it showing only double ended wiring, in both ballast and bypass mode. And for single ended wiring, is there a pin designated for...

My solution was to draw tiny dots with a pencil on the wall next to the side view mirror. I use three dots in a horizontal line about 1/2 inch apart. As I drive in, I look at the side view mirror and the dots pass by it. When I see the first one, I know I'm close. Just as the third one...

It's been a while, so I thought I post an update. Put peg board up and added a vehicle to the stable. 71 C3, 454 4 spd, factory AC, PS, PB. I love it. It goes well with the Z06. :thumbup:

Re: My 20 X 24 - Corvette Garage I've made some more progress and thought it was time to post an update. Got some nice cabinets from a local hardware store. Nothing fancy, but they are large and can hold a lot of stuff. And they come in a nice Gray color. They're made by ClosetMaid. Got a...

Wow, lots of questions. OK, here goes. 1. No. It actually rained this weekend, so I was in and out with wet shoes. It didn't feel slippery at all. It feels sticky actually. Like a squeaky clean, rubber on rubber feel. 2. No clear coat. 3. Even though I didn't use them, I know they...

If that's correct, that's less than a half kit. Plus no shipping charges.

I used 2 half kits plus 1/2 of a half kit (1/4) for my 20' x 24' garage. I needed the additional 1/4 kit because I came up short on part A. Still not sure why. For the most part, it looks great. There are a few areas were the concrete was more porous and/or I applied the epoxy a little thin...

Looks good!

Mine are for sale. $10. :bounce: It took me about 10 minutes to make these. Didn't even bother cutting them shoe shaped. They worked great.

Time for an update. I got the epoxy floor done. I had a couple of issues, but in the end it turned out good. I still need to touch up some of the walls. The masking tape was a little too strong for the sheet rock. Next I need to figure out storage. I want some nice cabinets with doors, but...

I'm finished!! I order another 1/2 kit and finished the last section yesterday. I was able to feather the two sections together pretty well. I just sanded about 3 inches of the previous section and carefully painted that edge with a brush. Thanks to Epoxy-Coat (Christine?) for taking care of...

lol. I meant pics of his garage.

My issue was that I ran out of Part A and didn't have enough to make the forth and final batch. I still can't figure out where it went. Maybe the leftovers in buckets when I mixed the Part A's together? I know I measured right. The measuring sticks in the half kit say a single batch is...

AArrrrrggggggggggg. I ran out of epoxy. I didn't have enough Part A. I can not figure out how this happened. Since I bought two half kits, I took the two Part A's and poured them both into one 2 gallon bucket. And it nearly filled it. So I know I had two gallons of Part A. I know I...

Flaking is pretty easy. I did throw too much on my first throw. I would start with just a pinch. A little goes a long way when it hits the floor. And it's pretty easy to get even coverage. I used a back hand flip motion and threw the flakes up high. But then for spot targeting, I would...