Recent content by ez3

Check out the sand beige as an accent color here. Going with the house color is a safe bet (as long as it gets painted the same later on) and looks real sharp when the doors are open. I was surprised at how much I liked the white. You could do the white and use orange flakes. I'm not sure if...

Haha. Thanks, AlphaGarage. So, far we love the way it looks (as does everyone else that has seen it). The top coat is great, super hard. Been parking in it and ended up dropping and dragging stuff when resetting it. So far not a scratch. And I am glad I did the SuperGrip. With the puddles...

I got it off Amazon for just under 400. Bosch does make decent tools but this does seem overpriced. Rated at 10 amps it has a bit of go but still. If I knew it was going to take that long I probably would have looked into renting something. As it started it was an excuse for another tool...

:beer: Hahaha. That would have cost a whole lot more.

Yup. The old stuff (NOT Wolverine) was peeling up real bad - coaster sized chunks. I'm guessing the etcher that came with it wasn't up to the task and didn't do its job. That and the temperature was right at the recommended minimum. It came out to be over $2 a foot. Getting more than one...

Thanks for the compliment. Yeah, it was a lot of work. I used the one that came with the grinder which is a DC510. Didn't have to replace it and there is still lots of life left.

All because the woman didn't like the color. It took probably 35 hours of grinding to get the old stuff up. The Bosch 1773 concrete grinder was the workhorse of the operation. It was abused and kept on going. There wasn't anything tough about it except for the calices on my knees. An angle...