Recent content by fastleft

Looks great. I’m rebuilding my newly acquired jack today and then will be doing the same.

Sign me up too!

I installed mine and it works great. Not hard to design if you know check the flow rates per head and group / match them to your water supply. I think lawnsite has an irrigation section. Spend some time looking at the catalogs and install guide from the manufacturers and sites like irrigation...

I bought one a while back for my shed from Trac•Rite . I can't remember how much it was, but it was much cheaper than a prehung double steel door. I had it shipped to a freight terminal and I picked it up there. Quality is excellent.

Nice design on the latch. Thanks for the info. Will have to do something like that as well.... I can't stand rattling either!

Looks great. Can you possibly show more detail about the tailgate latches? Look nicely done. I just made a gate for my trailer and I hate the latch I made, would like to upgrade it a bit. Thanks Tommy

Very timely question..... about to do the same thing on my 2003 F-250. Looking forward to others responses!

Pepi. Thanks much thats perfect! I ordered one yesterday as well and I have more than enough to hook it up already. Wasn't sure what I was missing that was included in a $60 box of fittings and plastic tubing! Thanks Tommy

Pepi, That looks like a great setup. Looks like you did not purchase one of their installation kits. Is that regular 1/4" copper tubing with compression fittings? I see the T/valve you mentioned that you used on the bottom, just curious how you connected the line up at the unloader? Did you...

Does anyone know of the best place to buy a new Hein-Werner HW93652 3 Ton Service Jack? I've been looking and have seen it range in price from $409 with free shipping up to $850 + 125 shipping! Was just curious if the $409 is a decent price or of there was a better deal to be had anywhere...

I had a similar problem with my Kenmore (made by Whirlpool) and it's likely the agitator dogs that have broken. If so it's super easy and cheap to fix. Take a look at this page, especially the "Weak or No Agitation' section. Should explain it pretty well and you can order the parts from them...

Thanks for all the replies. I agree the whole situation is fairly ridiculous, but as mentioned it is New Jersey after all! I got the permit because the deck will act as the entry point to the pool and as such must meet the gate/barrier requirements.... don't want any problems in the future...

I know this isn't the most appropriate place to post this, but I'm sure more than a few of you have built decks and stuff outside the shop! Hope its not a problem. I'm building a deck around a portion of my above ground pool and I submitted plans, got the permit, etc. Next step is to dig the...

I'm not 100% positive, but I believe the HEAVY WIRE PEG BOARD HOOKS from McMaster Carr are for 1/4" peg board. The catalog page mentions "Hooks fit tightly into 9/32" dia. pegboard holes, securely holding heavier loads." If you look on the previous page (hit the left arrow to get to pate 2994)...

I've been on live chat too... told the same thing and everytime I ask how/who to request the price adjustment they disconnect me or transfer me to another operator and I have to start the whole story over again.... I really can't stand Sears website!