Recent content by Fei8lo

I am using this filter with metal bowl. http://manualarchive.ingersollrandproducts.com/ir_pdfs/Fluid%20Technologies/ARO%20Fluid%20Products/Air%20System%20Components/253XX-***-EN.pdf I got it cheap on ebay. Unfortunately it had some rust and I placed it in evaporust and it took the rest of the...

I was worried about the 200 PSI pressure test ratting of the cooler at first but it was the only affordable after cooler I could find at the time. My biggest concern was if it did fail, would it be dangerous. I figured the cooler was designed to withstand over 200PSI and 175PSI should not be a...

I run the air stream through a filter (large black filter with its own drain) before it goes into the tank to minimize water that ever enters the tank. I figure this will extend the life of the tank and replacing a filter is easier and cheaper than a tank in the future. Also, I have noticed...

I am running the biggest passive cooler from B&M (70274). Drops the air temp from 400F down to ~100F. I had one cooler fail due to vibration because I was using black pipe with no vibration isolation (quick substitution after PTFE tubing/AN fittings failed). Fittings were returned and B&M...

5HP IR from TSC. Some additions to the basic compressor. Magnetic starter B&M Transmission cooler for after cooler Custom belt guard to hold cooler Rand filter/water separator to remove water before entering tank 1/2 muffled drain valve Intake silencer from McMaster Carr Future plans Custom...

When I did my testing I held one side of the door up and it caused that side to unwind a bit and not the other but the motor detected the difference from the programmed load and reversed. Having a second monitor would help if the door closed at an angle causing slack in only one side which is...

Is there any real purpose of the cable tension monitor when there is only one instead of one for each cable? I tested the opener by holding one side of the door up and the cable slacks on one side then the opener reverses with no monitor installed. If I an going to bother installing the cable...