Ferrstein's latest activity

I can vouch for Frank's #2 technique. I had soaked mine for about a week, then applied heat to the base, on both the top and bottom...

That's a good idea. Will keep it off the floor to prevent any further rust as well.

Yeah. These were made in 62" and 67". I'm fairly tall, so that height difference means a lot to my neck. If I had any fab / weld...

It's too tall for most hydraulic presses. You could try heating the casting, in one spot until dull red, but you NEED oxy acetylene for...

There's quite a bit of vertical engagement in that column. I think I'd be closer to 62", and I already have a 62" post here. Rather...

It doesn't. I just wanted to get it cleaned up and repainted. I can do that with them assembled if I have to.

I have a nice 62" column and base here. For that reason I will stop short of cutting anything. If it comes to that I'll just leave...

Good point. I have the area soaking in Kroil now, but I'm fairly certain nothing can make it down to that cavity. I'll get that done...

Thanks Frank - That's a great document! I love the "In order of increasing aggressiveness" layout. I'm pretty sure I need to go...

That's a great thought. I have a bottle jack and also a porta-power I could try. I think I'll try separating it via non-destructive...

Hello all - This may end up resulting in defeat, but I thought I'd ask here - any thoughts on removing a drill press column that seems...