Recent content by FFRSpec72

Ha ha, just doing some rearrangement in the attached living space, all gone now! Believe me I have see enough furniture in the workshop as we had to move out of our has and the new one was not doe yet so all got stuffed in the workshop

Just added a Foot Stomp Shear to my collection, this was heavy!

Here is the dyno sheet

So I was the SOVREN Big Bore Champion last year (2018), before that I was ITE Champion in Conference League and have been SCCA reginal Champion. So I do OK, not the fastest and not the slowest. Quite a few cars and adding more.

Dynoed at 520hp and just under 450 tq, on pump gas So I run at Mission BC, Pacific Raceway, Spokane, Portland, Grass Valley Oregon, Sonoma and the Ridge.

Here is another one of my race cars

So this was built in 2004 as a Spec racer, ran the spec series, then upgraded to new specs in 2014 when rules changed, so was at about 300hp/300torque and now this is going to get a radical engine change. The suspension, tires, etc. and all will stay as Spec Racer New Engine: 302 block with...

I did use the Gladiator Shelfs for parts (transmissions, etc.)

Construction and after, shows the beam for the hoist

Teardown time on one of my race cars

Baldhead Cabinets installed at back of RV bay wall

Here is the shop and attached living space plans, it was made 500 sq larger during construction

Here is my 100,000 BTU Heater, very nice this time of year and heats the 2500 sq foot shop very well

Here is an aerial view of the 3 buildings, garage/shop is on left

Well there is also a new 3200 sq ft main house and a 1500 sq ft barn.