Recent content by fhemm20

^this Also, build a little pressure (around 50 psi, more if your discharge is close to the same size as your suction) before opening a discharge 100%. Too much pressure drop at once and you will lose your prime, especially at lower engine speeds. Opening valves slowly will also help reduce this.

Got another scratch and dent tool box, this one is for the house. $350

Lisle makes them too, only $40

So I was working about 2 hours from the shop today. When I got to what I was there to work on I realized I had forgotten my ball pien and punches for 1 roll pin I had to pull. I turn around and the Cornwell guy had just pulled up about 50 yards from me. 16 Oz ball pien and roll pin punch set for $80

NP1, it will be there forever. The mild steel will rust away before this stuff gives up. http://www.amazon.com/gp/aw/d/B002YPA0FO?pc_redir=1402541398&robot_redir=1 Sent from my SAMSUNG-SM-G900A using Tapatalk

What this guy said Sent from my SAMSUNG-SM-G900A using Tapatalk

I think I got it figured out...

Ok, tapatalk is being uncooperative and not loading pics...will load later Sent from my SAMSUNG-SM-G900A using Tapatalk

Built my first gate. 1" square, .065 wall. All tig welded. stainless hinges and latch bolt are welded on. Sent from my SAMSUNG-SM-G900A using Tapatalk

I would get one as a top box, but not a bottom Sent from my SAMSUNG-SM-G900A using Tapatalk

I'm glad this torque wrench thread didn't end up like the last one [emoji16] Sent from my SAMSUNG-SM-G900A using Tapatalk

I thought about saving the money and just milling out a few 6 point sockets... Sent from my SAMSUNG-SM-G900A using Tapatalk

New to me Milwaukee 6176-20 In good shape, no slop in pivot. $125 Sent from my SAMSUNG-SM-G900A using Tapatalk

Must be a popular item... Sent from my SAMSUNG-SM-G900A using Tapatalk

Has anyone here used the sunex 13 pc weatherhead socket set before? I was wanting to get something that would let me remove machined brass 90 degree fittings from the top and was curious how well they would get the job done. http://www.tooltopia.com/sunex-tools-9913.aspx...