Recent content by fitch

I am set up on 120 Gallon tank now. I was on 100# cylinder. When you put the foam board over top the 1" foam board you put between the girts, did you frame it or just nail the board to the girts? What size foam board did you use? And last, what did you attach the OSB to? Thanks

Ceiling has about 12"-15" blown in insulation. I only run the heat when I am going to be out there. I don't know how cold it is when I start the furnace. I guess the answer would be whatever the outside temperature is which varies in Michigan -10° to 40° ish?

Pic of heater set up.

As far as insulation, I was going to do 2" foam board between the 2x4's that run horizontal (purlins?) but then, spray foam isn't that much more. Just a lot or work to get everything off the walls so that the company can spray. Is the foam board an option? The ceiling has about 12"-15" blown in.

The furnace is now about 3-4 years old and maybe I need to look at a higher BTU... Reznor, Modine....

I didn't call them back. They left me with,"the walls should be insulated". Maybe the third times the charm.

I'm not sure about the pressure valve inside. I had the furnace installed by a heating contractor.

Would I contact my propane company, (they set the tank and regulator was on it) or heating and cooling tech?

* I think I posted incorrectly earlier* Please see below. Mr Heater struggles with heating my 24x40x10 Pole Barn. I have the ceiling insulated but not the walls and the heat coming from it is not very much. Prior to buying, I spoke with technical service at Mr Heater and it was suggested I go...

Mr Heater struggles with heating my 24x40x10 Pole Barn. I have the ceiling insulated but not the walls and the heat coming from it is not very much. Prior to buying, I spoke with technical service at Mr Heater and it was suggested I go with the 75K btu and it would heat fine without the walls...

Thanks to all. I appreciate the options.

Spray foam was a little on the expensive side. Being in Michigan it would be the most efficient way. As far as being very flammable, is there a special foam board that would work better? Again, not sure about the infestation issue either.

Looking to insulate my 24x40x10 pole barn walls. I am considering foam board. My thought was to either cut it and put it between the 2x4 perlins that run long ways, or place sheets over top of the the perlins which would leave a gap between the board and steel siding. Speaking to some, they...

When I look at these at Tractor Supply, the F273767 didn't have the nozzle like F276136. Did you have to purchase the nozzle for the tank seperate?

can you tell me what regulator you are using? Mine is Mr Heater # F276136. Mr heater tech suggested F27367.