Recent content by fitzgr8

Looking to have a 900 sq ft garage floor done and was looking for advice/opinions pros/cons on either coatings. Thanks

I need to tig and old bulkhead from a snowmobile for a friend of mine and was wondering if anyone has any tips. I know how to weld new/clean aluminum but am not used to old dirty stuff. I do have a stainless steel wire brush to clean the area up good. What filler rod should I use. Thanks, Fitz

Or two much moisture in the concrete.

http://www.bontool.com/product1.asp?P=PORCUPINEROLLER You needed one of these. Same thing happened to me and I was ready for it!

So I ended up putting a "T" inline as shown and all is well now. Spits water out every time there is a 20psi drop.

I need to "T" the 1/4 line into another location other than the unloader line I guess.

Any idea on how to hook up to a "unregulated line pressure". Does this mean I have to "T" off my line where the airline is hooked up?

"ARDEX CP™ Concrete Patch" best stuff money can buy for spalling and pitted concrete hands down.

Hello all. I am having problems with my Wilkerson X51 drain and was wondering if anyone else on the forum has one installed. I have it "T" from the unloader line on my Cambell Hausfeld 60gallon 7hp compressor and when the compressor reaches its maximum pressure and shuts down the valve opens and...