Recent content by Flashnine

Well I followed some quality advise from you guys, and after some effort actually got the pins out and removed the rollers. Wire wheeled everything, I think about $15 worth of roller bearings and a couple of snap rings and they will be up and operational. Thanks again! Sent from my iPhone...

Mine is for my garage at home so I feel it was a worth while investment. It has a wheeltronics decal on it as well. It appears that there were two models offered by snap on, earlier models look as if they had a single piston and a 6000lbs rating with an open top. And a later model "mine" twin...

Good info, thanks. Sent from my iPhone using Tapatalk

I'll look for those, seems like some sound advise. Thanks. Sent from my iPhone using Tapatalk

Ok so after a little cleaning with a steel bristled brush I see that there are snap rings holding the pins in. I have soaked the pins, and rollers with some PB Blaster for a day, I tried some heat and even an air hammer but no luck. Sent from my iPhone using Tapatalk

Not sure if I'm posting this in the correct spot, but I'm looking for some advise. I just purchased a used Snap On mid rise lift, after performing a thorough inspection, I have found the metal rollers that contact the floor are seized. Has anyone found a way to free these up, or had any success...

Just joined up after poking around for some information. The more I read the more I liked the group, great bunch of guys. Sent from my iPhone using Tapatalk