Recent content by Flynman

Ok...Sales Rep said there should be a slight outward tilt to the posts and Directions say to level and plumb posts. I am going with Directions. Need 3/16 shims on the low side due to outward pitch of garage floor and 1/4 inch shims on back side of base to get the posts within 1/8 inch of each...

Very Nice!! Enjoy it to the Fullest!!

Ok so I called National Auto Tools and spoke to the Rep there. He said you should level the bases and that as long as the bases are level that there should be a slight back bend in the lift tower that will come slightly forward when the lift is loaded. However in the manual for the lift it says...

koditten did you just shim under the edges and leave the base slightly tilted and nothing under the middle area of the base? Or did you pour anything like non shrinking grout so the entire base was touching the concrete pad?

I will give the Manufacturer a call !!Thank you for the Replies!!

Yes both base plates are level side to side and Front to back. Vertically the faces of the 2 posts are leaning backwards 1 1/2 inches from each other at the top as compared to the bottom. That seems a little excessive considering the base plates are level all around.

Hello Everyone!! I am installing a Triumph C7000 2 Post lift in my garage and I have an issue with getting it level. I poured 2 3x4 concrete footings which are level front to back and about 1/16 off side to side due to slope out in garage floor. I drilled all of the anchor bolts and set both...

Hello to All !!! New to the board!! I have been working on Cars, Guitars and woodworking for quite a while and finally have a Garage and house big enough to fit it all in one place!! (well most of it) Looking forward to being a member of the Board!! Thanks...