Recent content by foghorn1966

I still like corded tools for hi load use. And I still think that battery platforms might have the rug pulled out from them again for newer tech.

Saw these for the first time @ Princess Auto this week. https://www.princessauto.com/en/2-pc-1-4-in-dr-nano-ratchet-and-ratcheting-bit-driver-set/product/PA0009413626 Shorter than the Titan ones. Slightly thicker than the Titan ones. Will prob. pull the trigger when they go on sale.

Same thing happened on a LG refrigerator a few years ago. Soldered on standard sized glass fuse with lead ends on the control board. New board $450, Has to come out of Toronto or Florida. Appliance tech booking a week out too. Took the board to my local electronics repair shop & they soldered on...

Yes Sir. Seal kit with 2 o=rings. Robinair kit #19150 "O-ring kit for 18190A & 18191A Couplers"

Just went thru this myself on a set of Robinair 134A couplers & there is nothing easily found on the 'net on the o-ring sizing. The official o-ring set is spendy, $25 CND wholesale for 2 o-rings. I suspect that they are HNBR mat'l. Hi side large o-ring #113, low side small o-ring #111. Attached...

Or this mfg. I have a double electrical pouch setup with suspenders that I use for shutdown work. https://vikingleatherproducts.com Ordered direct from them.

I'm liking this thread. In to watch.

Cannuck there is alot of old 2A "dumb" chargers there in the homeland. Keep garage sailing & tell the family you are looking for (send them a pic).

Nice save there Trainer.

Does not help with your space problem. But does not tip over like a 5 gal bucket. Sounds like you have a dead vac already.

If getting pairs of wrench sizes. Get a std wrench & an offset wrench (14, 18 or 24 inch). If getting cheap import aluminum ones watch for the stationary jaws to be parallel to the moving jaws. I received one that was unusable due to that

The new ones are not any better if not worse than you have. Fab up a switch or replace the switch with a paddle off one.

Suggestion, try adding a link belt.

Great job OP! For Girchy above & myself. Please post details on the fibre wheel you used heavily on this resto. Thanks.

Nice set-up! I ran a van for a number of years until switching to a slide in unit.