Recent content by foolio

Scooterj, my man (or woman) 🤷‍♂️, I think you found me a winner! And a fellow Hoosier too 😀

I actually found that exact site but alas not really what I am looking for.

Unfortunately, the ones I am finding specify a specific max output in watts. Not sure how that figures since normal dumb switches seem to only care about amps. Must be something specific to the brains inside the switch.

Hey thanks for the reply! I did some digging on the one you suggested. In the spec sheet, it mentions 600W incandescent. Not sure how that translates to LED. I think I will see if I can get a response from the manufacturer.

Does anyone know what I can get for a three-way smart switch that will handle high output? I have nine 110 W LED high bay lights In my garage. I ordered a three-way smart switch from Amazon but when I got it I saw it could only handle 200 W. so far in my searching I have come up empty-handed.

I was less specific when it came to that. I suspect I measured to what I thought the center would be. I was more specific just to find the corners of my pad area so as not to drill into the radiant piping. Even when I had the lift professionally installed, I just pointed to the the 3x3 squares...

My barn is 40’ deep. I put my “pads” 15 from the the inner wall so I could have a car parked under or on it and still get a vehicle behind it and have work space in the front. I added a few photos showing me with multiple measuring tapes marking out the coordinates of where radiant floor heating...

Sent you a pm...I was not getting alerted to new message.

This is not directly what you asked for but I have the Titan (I think it’s only 6k lbs.) that I bought 7 years ago. It’s seen A LOT of usage and I have yet to have a single problem. So, the quality for me has been top notch.

Wow, wish I had seen an idea like this before built my barn last year. Great idea!

For Torx, I like my Wera.

Would love to see a picture of this. I have been thinking of coming up with some sort of folding staircase but have not figured out the best approach yet.

I have 14’ ceilings and built out a workshop in one part of the barn. I was deciding basically the same thing you were. In the end, decided on 8’ ceilings in the shop and ended up with about 5’ ceilings in the loft. It’s only used for storage. It’s a little bit of a pain when I have to go up...

I have installed the 100’ maxline system plus some extra tubing to get it where I needed it. One thing I thought hard about was straightening the lines. Decided in the end I would give it a go by hand since I am more cheap than I am particular. It actually turned out ok and I have some long runs...

Welcome!