four.cycle's latest activity

Well looks like she’s a CAT box

@RTM - Not sure if you pursued that patent above, but: I went through everything I could find online. No mention of Harry Millward at...

Go to a thrift store, pick up an old remote control, pull batteries out, and you will find the correct springs.

125mm Knipex Cobra

It is not reasonable to expect every business on the planet to run the same hours as you.

Hello there @Barten and welcome to the site! keep this link handy and this one

I needed an 11/16" 8-point a few weeks back to remove a square nut that was in a place I couldn't get at with an open-end. Rather than...

Just in the 1/4” drive sets. The 1/2” drive 8 point sockets are readily available in regular S-K knurled sockets but they seem rare in...

I picked up a couple mixed lots of tools from an auction yesterday and found this gem while sorting them. Herbrand No.822 door pin...

He wouldn't. Expecting "average Joe" to know the difference is delusional. Feel free to tell me I'm stupid, but I had no clue.

ahh okay.... I think the first time I had to cut down a screw I was maybe 12 or 13. I had a tiny 2-inch clamp-on vise on my desk in my...

The cutting screws issue is a bit off topic. Someone mentioned Klein D-2000 cutters being able to cut “a lot more than that”. Hakeem...

Sorry... my mistake... I've been pretty sick and haven't been thinking straight for the last week. I should have looked first. I...