Recent content by GarageTodd

Thanks for the help. I am just very bad and understanding wiring

Not labeled on the switch. Motor has both labeled as Line.

Which side of the switch is line side and which is load side?

So I hooked it all up and think I did something wrong at the switch. Are the line/load terminals both top (white / black) “on” and orange / red bottom “off” or left and right sides of the switch (when facing the drill press)? I wired it like this and when plugged in, it goes on but switch won’t...

Thank you so much, Greatbear! Super helpful. I was able to get the line cable through both the inside clamp as well as the hole in the back of the drill housing, but barely. The OG wiring harnesses were so dried out it was difficult to see wire colors. I will try what you suggested today, I...

I really need your help! I’m trying to rewire mine but can’t figure out what goes where. I have 5 wires going to the front switch, but can’t figure out how to wire them to the motor with the 3 wire plug for the outlet. The motor only has 2 posts plus the ground. The OG wiring was all attached...

I have the same drill press and I am trying to reattach new wiring. I didn’t snap a pic before taking old rotted wire off, and now not sure how to reattach. 5 wires from switch, 3 wires from plug. Any help or pic of wiring diagram would be a huge help.