Recent content by gas guzzler

Thanks

Can someone suggest a decent driver set for occasional home use for wheel bearing seals and such. Doesn't need to be the best as I may only use it every ten years. Thanks

The PI is new and as far as the beam wrench I don't think there's much that can go wrong with one of those is there? It was an army wrench but I'm not sure if they can be used enough that it will weaken or start to develop a memory or not.

I just bought one of these and was curious if anyone can tell me anything about this wrench? Original cost, quality, etc? http://www.ebay.com/itm/Sturtevant-Richmont-Torque-Wrench-R600-/110816220640?pt=LH_DefaultDomain_0&hash=item19cd2955e0 Also, I hooked this wrench to my new PI split beam...

Thanks for the good words fellas. I called quite a few places that supposedly had the PI in stock according to their website, including tooltopia if I'm not mistaken, but no one that I called had them. They make a few different models and I didn't ask about each and every one, the model number I...

Has anyone ever seen the 20-100 ft lb wrench with the blue plastic handle or do they only put that handle on the 40-250 lb wrench?

Well I made my decision and now the shame. I tried to find a PI or Armstrong to support my country but their wrenches are 2-3 wks out while the CDI was in stock. It's sad when outsourced communist junk is more readily available than domestic product here in the homeland. I was told they are made...

tttt

I'm fixing to order an inch pound micrometer and I've narrowed it down between the 50-250" CDI and the 30-200" PI. I had decided on the CDI but with the ratchet head being foreign made I'm second guessing the decision. The Precision Instrument I have been told is 100% domestic. It also says...