Recent content by gdlmwr

2x on retorque of lift. Verify torque specs. Most recommend 90-150 ft lb. hand torque only.

Thanks for feedback, I was thinking the rotary's have two piece columns so I might get away with it if disassembled. Doesn't sound like they get much shorter on length. The reason I even asked was I thought I watched a YouTube video of a guy installing a new one out of the back of a pickup...

Ok 2 post lift removal and transport. Rotary 7k lift, can I disassemble and loaded into my 6' bed truck? Thanks Gary

Been lurking for a bit and searched for loft ideas. Here's mine looking for some advise. 28ft accross 6ft deep. 3 runs accross 24" on center. 2x6 sitting on top of wall. Want to tie to trusses. Should I tie from truss center of new board or splayed out ^ or like existing truss to center ¥...

Sims5, This thing is well WOW! I was torn between finishing the inside of my stick building with corrugated steel or good old drywall. I have to go with steel, yours is exactly how I see it done. Did you get the sweating issues corrected to your satisfaction? I finished my electrical...

I had a similar issue with HF coupons in the past. I found if you first try to use the coupon online and it works (simply cancel the order) than it works in the store. The cashier can do the same thing they can scan it for everything if works done if it doesn't then not eligable. Store...

Re: Newbie 28X40 pic inside Thanks, I'll check the FAQ section. Should have thought of that first:lol_hittiv

How to upload pictures, CORRECTLY

Interested, pickup in Detroit. Any left?

Hi, Newbie been lurking for awhile. Just bought a new house with a must have 28X40x14.5' high garage. Struggling to get really going on the garage, still in the planning stages. Cleaning out old owners ****. Working with what is already there. Has 100 amp service panel, some wiring, lights...