Recent content by generalsparky

No, i guess it's fine. It's not slipping, but it kinda bouncing a bit. It might stop when I bolt it to the ground. Yeah, there are slots, so do you take the belt off and then move it or do you move it with the belt on?

It's working great now. Fills the whole 100gal tank to 120psi in about 3min. Thanks for your help I was really stuck. I searched online for help for weeks before I came here. I do need to tension the belt, is there an easy way to do that? I tried unbolting the electric motor and stuff but I...

Thanks for everyone's advice. I'll replace the check valve and report back.

Is it what I circled here? Or maybe at the bottom of it? Know where I can buy a replacement? Is this it? https://www.amazon.com/dp/B00NU50ZPM/?tag=atomicindus08-20 I guess I need to take it all apart to make sure I'm getting the right size fittings/ends.

Check valve, umm, not sure what that is. Researching... Uh, I think it maybe this submarine looking thing the pressure control switch screws into?

when it goes off i see a spark on the control switch and it lets out air, but both switches failing same way and 1 is brand new. Just blows my mind.

Thanks, does that mean I need a new switch?

So I replaced the pressure control switch but it gets to 120 psi and then the switch releases air, from safety valve I think. Won't stop until it releases a lot of air almost all of it. The old switch did the same thing. Not sure what's going on. I did some research i thought maybe it was the...