Recent content by Genuine GM

  1. G

    Milwaukee M18 Compact 3/8 Impact Wrench - Do I Need One of These?

    The M18 3/8" is my go to. I only use the M18 1/2" for things that are really on there, or suspension/chassis bolts over 1/2" diameter. You won't be disappointed.
  2. G

    Tooling (Re)Organization

    I’ve read the first thread at least twice. Subscribing to this was a no-brainer.
  3. G

    Between 485 & 705 SQ/FT BJ383SS's Woodshop/Garage

    +1 on where did you get the T9 stuff. My old Craftman tablesaw could use that.
  4. G

    Tooling organization

    Never mind, I see they did a run in October. Dangit!
  5. G

    Tooling organization

    Where did you get that? I thought the Framing Square was a One-Time Tool?
  6. G

    Tooling organization

    First, I've been following this thread for years. It's been very inspirational. I see an MFT, how do you like it? For the real question. In the tool tote, what are the handles with the red, blue, and yellow end caps? They look like putty knives, but that seems like an awful lot for the...
  7. G

    Question of DZUS fittings

    I did too. That is weird, wonder if it has to do with the fact they are pdf links?
  8. G

    Question of DZUS fittings

    Tridair Fasteners are even better, but they're about $30 each. You can order them from SkyGeek. http://https://www.alcoa.com/fastening_systems_and_rings/aerospace/catalog/pdf/AFS%20Tridair%20-%20Mark%20IV_rev_B.pdf
  9. G

    Question of DZUS fittings

    I work in aviation. Dzus is ****, you want Camloc at a minimum. http://http://m.aircraftspruce.com/categories/aircraft_parts/ap/menus/ha/fast_1camloc.html
See more
Top Bottom