Recent content by GEORGE T G

I played with the 3 screws that I didn't know were there. It's getting better. Now to figure were it should be. I am a Gates dealer and a fan of good belts so I guess I will order them from my jober

:thumbup:That is a big help. I will have to look for the other three screws. I take it the belts are 20", 21" and 17"

I only see the two and can't stop the plate from sliding around

I see two countersunk screws , should they be tight enough to hold it tight. ? I was looking for a bracket and holes.

Thanks !!

I have an old model 150 drill press with the speed control knob up front. It's not attached which I know it should be and I am not understanding how it works. any information would be appreciated.

I finally got to takeing some pics of the drill press. I have them in my E-mail but cant get them to load here. I guess I could send them out and you could see them and/.or load them. Thanks, GEORGE!! [email protected]

I have an older Craftmad drill press. On the side it says 150 but doesn't look like the one I saw pictured here. It has a leaver on the top out front ans shows speeds. My questions is how does the belts route? They are on screwed up now and the pullies are out of alingment. Maybe they are wrong...