Recent content by GeorgeT

I bought a set of nice, adjustable spiked shoes from Fred at Alpha Garage but did not need them. Will ship to the 48 states for $20. Thanks, George 937-671-0768

YES! In addition to using carpet runners in the main walk area, I am going to add shark bite to the next coating of Endurashield. I was hoping to have a "smooth as glass" look but being practical is the way to go.

The prep work for the clear was pretty easy. Just lightly sand the VCT with 80 grit...vacuum the dust and then wipe the floor with a light dish soap and water mixture to make sure no dirt/grease was left behind. Since the VCT was just laid down and not used yet, there were no real...

After months and months of reading this excellent forum, I finally have something to post. Thanks to Fred at Alpha Garage, I have finally finished my floor in our new garage addition. I finished the VCT last Fall, but temps dropped too quickly to apply the clear epoxy until this week.

I am doing mine right now....Armstrong VCT adhesive says 65 degrees minimum on the label. If you have heat, and can keep your garage doors closed, you should be OK. Be careful of the air/slab temp near the doors...especially if they are not insulated. I have been doing the majority of the floor...

If you don't mind, where did the top come from and how much does it cost? Thanks, George