Recent content by gixer007

I built one like 57pontiac but I dont have the windows on it. Mine is full. I used a strainer for a sink that fit right in my tube. I then put window screen in the strainer. Th idea is the strainer takes any weight from the desicant and the window screen stops any smaller parts from going...

Run down to harbor freight and check the ones they have out. Or just check out a scissor lift at any rental place to give you ideas.

Are you sure its NOT steel. All the pitchng macines I have seen and used were steel not aluminum.

I hav two toll boxes and then I have smaller set in a cary case. Each on in th case has a home. Every thing is there an labled. Thats where you an borrow from. If there is some thng missing then you lost it and have to replace it. Thats how I work it. I use the case when I hit the road so...

normaly 1/4

Yeah I dont care about the stain I just need to get the oil out of the wood and get rid of the smell. Its a floor its going to be dirty and stuff.

Hey Ok I have some gear oil spilled on a wooden floor in a shed. Tearing up the floor is not happening. It stinks so how can I mask it? Some one mentioned to me to paint over it but I dont know how that will work. Any other ideas? Thanks

And people wonder why I have a motion sensor and both doos hooked up to my alarm.

Thanks

I know I know. I should have but it was one of those late night I cant sleep what do I do at 2am type of nights. I figured at the time who wants to see pictures of pipe. I should tell you guys what I did for the screen in side. I found some pvc pipe....yes I said it pvc and I used it inside...

Any link to aa manufacturing ? I did a search and didnt find any thing with tabs.

Well I finaly made mine. If I knew how to post a picture I would but you would not really see much any way. 5 foot 2 inch pipe that is rated at 300psi. Put disconects on each end. I am running 1/4inch dessicant threw out. I have screens on both ends and its packed full. I can tell you I...

dont use a T to plum it in. Come in one side on the top and out the other side on top. This way as the air gos inot the tank the water can go to the bottom of the tank as it cools and you pull dry air off the top of the tank.

I am running the two tank set up for my small compressor in shop. I made a dessicant dryer for my plasma cutter just to be on the safe side. Works great. You can get search on line for auto drains but if you just drain your tanks daily you should be fine. Unless you run the blast cabinet all...

Yes you can use it as a wet tank dry tank set up. You would be using your 60gal tank as the wet tank. Try to get as much distance between the two tanks. This helps cool the air on the way to the second tank. Then the second tank becomes the dry tank. Hoping the water will collect in there...