Recent content by goblue1998

I also have a small ryobi that I’ve had for 6-10 years. I’ve been happy with it.

Found this welder in a ditch half under water near my home. Currently being torn down for scrap.

I also had a great experience with the weighted socket on my Honda crank bolts. Took it right off with an older Milwaukee mid torque.

They have a good price on the m12 underhood light (with a 5.0) but I’m waiting for my refund from the band file before I order it.

Thank you. I got 3 for $33 after shipping.

Where are they made?

I painted a bunch of cabinet doors with a used turbine hvlp setup. Worked great spraying a latex enamel without thinning. I also invested in a spray tent. The tent was great for a minimal investment of like $60. Keep in mind both a gravity feed gun using an air compressor and a turbine fed gun...

Did you do two separate battery orders or just one?

You need the welded tag on the tank. That will tell you the pressure rating.

I have that plasma cutter. I’ve not used it much but it worked great. I think I paid about $175.

I have that set. It is decent and covers larger snap rings (wheel bearings).

I had the same problem and fixed it a couple of weeks ago by changing the switch. Mine was the 7-1/4 fuel. At the time, these guys were the cheapest. https://quagmirerepair.com/milwaukee-23-66-2639-switch-diode-assembly.html

The surge is much quieter. Hd has the bare surge and a 2.5 battery for $150. Well worth it in my opinion. I sold all my impact drivers and only have m12 and m18 surges now. If you are new to Milwaukee ask your friends for a m12 charger. They probably have one to give you. I have 3-4 I’d give...

Yes, by the plug. I was concerned but no issues since then.

I bought a similar one off Amazon and in the first few hours it blew a fuse in the unit. I changed the fuse and no issues since then.