Recent content by gorawr

After reassembling the pump pistons, no change in how it acts. I am able to slowly lift the arm. I did not have anything heavy to set on it so stood on the arm and it slowly went down (~215lbs).

Bought it in 2016 😅

well tried the troubleshooting steps and still will not pump with a load. I investigated the pump pistons .. I am assuming these need to have a oiring on the chamfered portion? I didnt see any o-ring remnants where these came out of. edit: after more research these may be the U Cup seals...

Quick update, So the jack is able to slowly raise up without a load, as soon as I try to jack a car up, no lift.

Hey Everyone, I purchased a Yellow 3 Ton HF Daytona Floor jack back when they were released a few years ago. Recently I came across an issue and was wondering if anyone knows a possible cause. I am having an issue with the jack raising its arm correctly on the down stroke of the handle but...

Are there any good deals on a m12 fuel drill/driver kit and a 3/8in ratchet? I think HD has a free tool deal with the $200 kit

If you had clicked my link you would have seen my electrical engineering degree.;)

Most electrical engineers are useless for stuff like this. source: http://i.imgur.com/PifGPgN.jpg

http://imgur.com/a/zuulK got mine for coastal tool a few days ago. welds look pretty bad, but they were super cheap at coastal.