Recent content by greasyfingers01

yes, blowing out of the condenser.

I got it running! The original motor was a 3 wire. The replacement motor is a universal motor with 5 wires. The instructions I had stated to terminate and cap the brown and yellow wires. After checking voltage looking at the wiring diagram again, the wires needed to be connected. I misunderstood...

The relay was working, compressor was kicking on. However, I replaced it anyway. It was 20 years old and was cheap to prevent future problems.

Yes I tested the new cap. It's reading 41.5uF and 3.12uF

Coming off the Cap fan and C? I haven't checked but will.

Unfortunately its a new motor and wiring.

My condenser fan is not working, the capacitor tested good but on the low end of the +/-5%. I could spin start the fan with the old capacitor. I replaced the capacitor and contactor given that its 20 years old. I still had the same problem. Then I replaced the fan motor, and still, the fan will...

Amazon https://www.amazon.com/dp/B00NG0VZ6E/?tag=atomicindus08-20 I will say I'm not too impressed with the Mitutoyo indicator. Its likely getting returned. Sent from my SM-A505U using Tapatalk

Do it! Did an inspection and well within the stated .0002" tolerance. Closer to .0001". Not bad for $35. I'm already putting it to work Sent from my SM-A505U using Tapatalk

I picked up a Mitutoyo test indicator and a 1" and 2" toolmakes vise Sent from my SM-A505U using Tapatalk

Wow! Super jealous! Congratulations. Sent from my SM-A505U using Tapatalk

Stopped at HD on my way home from work for a $3 jar of sample paint, left with a brushless hammer drill. It was on clearance $150. Comes with 2 4ah batteries and a quick charger. Sent from my SM-A505U using Tapatalk

I made him repeat it as I took the pic lol. "This is my string trimmer. There are many like it, but this one is mine. My string trimmer is my best friend. It is my life. I must master it as I must master my life. My string trimmer, without me, is useless. Without my string trimmer, I am...

I picked up a 9,000w Preditor on the cheap with a coupon ($600). Then I picked up a multi fuel carburetor for it ($30). Honestly if something goes bad, its going to be the carburetor, and thats not likely because I'm running propane. Also I can keep propane for a decade + vs 6 moths max with...

I've only used it on 2 chains so far. Kind of finicky to setup, but once you dial it in, it's super fast. I'm sure it will be a lot smoother after a few more uses. I suggest buying an extra burr in the beginning. I kind of jacked mine up in the learning process. Not too bad, still usable. I have...