Recent content by grenade inspector

  1. G

    New garage going up neighbor pitching a fit

    Posted from Garagejournal.com App for Android
  2. G

    Help IDing vise?

    Thank you all for your responses, I appreciate your wealth of knowledge. Would production of this lasted till the end of the war? That's my understanding of about when it would have been purchased. Does anyone know how to get the screw out? Also, anyone know what the original finish would have...
  3. G

    Help IDing vise?

    Hi, I was wondering if anyone could identify or tell me anything about this vise? I am planning to restore it and attach it to my (future) workbench. Thanks everyone.
  4. G

    Project: DIY Drill Press Stand

    looks good
  5. G

    Carriage door- Spanish Cedar

    sending pm...
  6. G

    KC Daylighters, Dana 44 cover,1/2 Drive Sockets

    Sending a pm about the kcs
  7. G

    Anyone ever modified a nail gun?

    Growing up in my fathers pallet shop Ive shot quite a few coil nail guns at things other than wood. I don't know about the new ones but the old guns you could hold the head right and fire them on automatic. Ran off more than one scumbag that way, killed a couple birds too. *don't try this at...
  8. G

    Help figuring out what I did wrong with my pallet jack seal kit

    did you check that the relief isn't open some? We've gotten some for free that were"broken" and all they needed was the relief adjusted a bit.
  9. G

    Is there such a thing as a good oil filter wrench?

    I always use the K&N oil filters, good filter plus it has a hex boss on the bottom (3/4" iirc), I just reach up with a stubby and spin her on and off, your son may need something bigger (no offense intended) but its by far the best design Ive seen for putting them on and off.
  10. G

    Aww ****! Just broke my favorite Matco wrench.

    get your lawyer on the phone, snap on should owe you some royalties :lol_hitti seriously though, sorry about your wrench
  11. G

    $200 Sander Options -- I need some opinions

    I got this > clicky ryobi for Christmas, I use it for some minor wood working, sharpening tools and weld prep on small pieces of mild steel, I like it a lot, the base is quite sturdy and after 5-10 minutes of dialing the belt in when I first got it I haven't had to mess with it at all. Its also...
  12. G

    New conscript from the HAMB

    welcome, Ive been a long time lurker on the hamb as well. lots of good info here, sorry I cant give you any constructive advise on dealing with a HOA and not going to jail
  13. G

    How come most have compressor inside?

    inside because the neighbors would get even more pissed off if I put it outside.
  14. G

    Great Garage Ideas! Aesthetics or Functional!

    There's an entire subforum devoted to this :thumbup: just seems to reiterate how you haven't spent 30 seconds considering that you are joining a thriving community which has done quite fine without your omnipotence and leadership for some time now.
  15. G

    a tool i didnt already have

    gonna leave everyone hanging like that? especially with the bait of an easy out that my actually be easy or get things out?
See more
Top Bottom