Recent content by grnova

bend pack sp7x full rise http://www.asedeals.com/scissor_lifts.html

Hey Scott, nice choice on the lift. I 've had my 7X for 2 or 3 months now And I love it! I did mine by flush mounting it in the floor, it and yes it takes shop air to release the safety locks. I used an air tank and mounted it on the inside of the control box, I Fill it to 100psi and I am...

I recessed the lift 5" in the ground. I did not want to lose the height(5") so I dropped the middle also, and since I have an Avalanche I thought I would go another 5" since my ceiling is only 11'4. Making the total recess 10". I am going to put aluminum 1/4" diamond plate down the middle to...

Hey guys that was a loooong wait. The concrete is finally cured so on with the lift install. Here are the latest pics. Enjoy!! http://img.photobucket.com/albums/v135/T_N_T/garage/HPIM0736.jpg http://img.photobucket.com/albums/v135/T_N_T/garage/HPIM0737.jpg...

this is the one I have been installing here is the link http://www.garagejournal.com/forum/showthread.php?t=2898

finally poured Well It took alittle while but it is finally concrete hydrolic line http://img.photobucket.com/albums/v135/T_N_T/garage/HPIM0706.jpg lower slab http://img.photobucket.com/albums/v135/T_N_T/garage/HPIM0702.jpg bases for lift and curbs...

When I am ready to pour I will have kickers, ties and spreaders between the plywood. And yes the plywood will hold I was a concrete carpenter and 3/4" plywood, this is all we used to use to build high rises downtown Chicago. Thanks for concern. That is why I am updating this so much, so other...

forming and backfill Well I must have over done it a bit , endended up in the hospital last week, that put a little pause in my progress. Well back to work , just need to take it a little eaiser this time. excavating done laying the 2 pads out building the forms for the pads and...

the concrete is finally out :rocker: :beer: :willy_nil

another day gone and I'm 1/3 the way done with removing the concrete (landscaping steps) not one has broken so far.

I cut the entire floor all the way through, then scored the floor to make it eaiser to remove. I am going to recycle these squares by using them as lanscaping steps. Well the first piece has been removed 4" thick.

here is a quickpic

believe it or not they are the bottom half of a stainless fridge. I got them because they were dented or scratched and replaced with new ones. Just cut the sides and bent them up for a top and bachslpash. Cool huh?

laying out Well just finished laying out the floor where the lift will be set in ( I made the cut out 6" bigger to make room for the forms and to let the concrete fill under the exisiting floor) . Drew up an idea of what I think it wll look like when it is done. Today I cut the floor and I...

it's here Hello everyone . I am so excited, I just went and picked up my Bend pak sp7X full rise scissors lift at my friends trucking company. We had no problems we just hoisted it off the flat bed and lowererd it onto my trailer. Here are a few pics of it in my garage. Now to lay out the floor...