Recent content by Guapo

Which box colors are easier to sell and which are hard to sell?

Why get this over the Astro, Aircat, or CP models?

So you pretty much paid for that epiq unless he gave you a lot for your trade-in. I've been thinking of making an inquiry for a KRL or Epiq and using my KRA as trade-in. I know deals vary based on area and dealer, but it gives me a ballpark. Thanks! :beer:

Is that after a trade-in box?

Why not just do draw test with a meter that has the resolution to begin with. Wouldn't that save time? I've always gone by an acceptable parasitic draws being <50mA. Of course that may depend on what the manufacturer says is acceptable after their turn-off wait times. I assume Fluke 376 would...

Starter amp draw = OK Parasitic amp draw = No Go The Fluke 376 has a 0.1 A resolution, which is not good enough for parasitic draw because you'll be looking to measure <100mA. I currently use a Fluke 87 and a low amp probe for most auto work, but then also a high current amp clamp for starter...

I've seen something similar on a DMM that was listed as a Fluke. I let the seller know and they promptly changed it. Mistakes happen.

Seems like a YMMV deal.

I thought Mac's hard-line stuff was still made in the USA? I do think it's annoying that they don't list COO.

Could their increasing prices be due to increase cost of manufacturing in America and them trying to maintain there profit margins?

Keep an eye on Amazon Warehouse for a deal on that set. Last time saw one for $180 on there.

I should have looked at the OP date.

I think the deal is dead. :dunno:

Any reason to get this over the new Fuel model?

I recommend saving your money if these are even close to the HF light. The HF light has a narrow spread and has a blueish hue. It was useless and returned it.