Recent content by GuyWithAFloor

Update: Used a product called "Pull it Out!" by Chomp, just found it on the shelf at home depot and decided to give it a try. It went on as a clear gel, soaked into the concrete, then dried white as it pulled up some grease. The worst areas dried yellowish...it was definitely working. Then I...

And a picture...here you can see the trouble spot next to the good concrete. If you look closely, you can see the spot it the middle that I "burned" with the heat gun. Thanks to everyone for the advice, you guys rule.

Thanks for the tips. Feel paranoid before you laid it down? 😬 That's where I am now...so humor me... I thought I was ready but I did another water test and noticed a little oil slick hovering over my test puddle over some trouble spots where cars were parked. Very small amount of oil, but in...

Estrellajon, I think there is a different wheel attachment for removing epoxy coatings. Check this video out...I used the concrete prep wheel (the one with more blades). The "removal tool" is apparently for removing old coatings/adhesives. But maybe someone else has a better solution...I'm...

New to the forum. I've been researching a bunch of information here over the past few months though -- thank you to everyone for the help. I've diamond grinded my 2-car garage (floor maintainer from home depot, fun but very messy) and I'm ready to apply epoxy. I researched a bunch of products...