Recent content by Gwhizman

no floor drain?

My 24 x 40 all steel with rollup doors

go the sawdust covered.. built-in dust collection in floor and both compressor and dust vacum located out back in a duty house to keep noise down.

Don't over think it...

A total of 7 overhead 4' tubes and 4 more under counter. One bulb fits all.

I used a 2 1/2 inch PVC cap that just fit the cap of the pendant. Drill a hole for the threaded conduit end and placed some pop rivites for good measure. Weather tight and works great.

4' florsent overhead and under cabinet (only one bulb to buy)

I was not about to pay 150 bucks for somthing I could build Original hanging light at Lowes on the discount table 11.00 EMT conduit and conectors and weather proof box 20.00 spray paint 4.00 Total 35.00 Bending the goose neck is the tricky part.

4 ft just fit the cross support in the peek of the roof I also used them as bechtop lighting. One common bulb is best in my book

That is correct the top are overlay .. they were built after the lowers and after a kitchen remodel that left me with a mess of old overlay hinges.

The cabinets are made from 5/8 plywood with face frames of ripped down pine shelving. The doors are the same pine ripped and mitered corners this allows you to cut a grove on the inside to accept the galvanized panel. The panels are no more than 5 V galvanized roofing (minus the outside V's) so...

Where's the cheep stuff? Everything I see is 100 bucks a gallon!

someone else had noticed the US flag was hanging backards and I did correct it and on investigation the Canadian flag was also backwards... corrected also. In my defence I was standing on the bench tops to hang them so from my prespective they were correct from my side. No disrespet was...

The doors are by Janus... new to residential the motor is in the tube not external.. very slick

Quite the project.. love the floor &next on my list