Recent content by H-D Dad

Ground is not bonded to panel. How do I tell if lug is rated or not for dbl wire? So from big lug on left bottom to ground rod #1 then 6 Ft to ground rod #2 single #6 bare cu wire. I did find a single pole 40amp. I will change out 30amp form main panel. Thanks every body for your help.

Yes it is . TV, window unit ac portable heater. Just a place to kickback. Thanks Wes

Hi everyone just now getting back to my project. Added a sub panel to my little cabin. I have a few questions. I ran an 8/2 with ground from a 30amp breaker in the main panel to the sub panel in the cabin. I put the black wire on one hot lug w/ a jumper to the other hot lug. I put the white...

Maybe it went to a ceiling fan or a wall plug. Have there been any renovations to the house? Good luck

Do a search for Froth-Pac for spray foam. My contractor had a minimum charge. Some neighbors and I split the cost. It came to $1.15 sq Ft. I couldn't DIY for that price.

Maybe this will work for you. Good luck. Wes

Thanks for the heads up on the liftmaster ill check them out. I have a big project going on now. I will start a new thread when I'm ready to start the automation age. Wes

Excellent troubleshooting practice.

I guess one of those t stats that you can work from your phone might not be a bad idea. That for the house. Also going to need 2 overhead garage door openers. I would like to use the one that goes on the end of the shaft. You guys or gals (in the future I will folks) want to throw out some...

I got approval from Pico engineering to move forward. I'm going to try to post pics of the method to my madness. this is the breaker fort the newly acquired park model it will no longer be used when new panel is set up. the meter on the right is attached to that breaker panel. It will be move...

Ill get pics tomorrow. Thanks

I want to add new meter, wire, and panel. Then I will disconnect newly acquired park model from 50amp panel (dbl. 50 and single 20 amp breaker). New panel will have more space. If poco allows me to go from new panel to existing 125 amp panel I will configure 125amp panel so it will be a sub...

I made a call to the poco this am. I was told to speak to Engineering. I had to leave a message. Hopefully they will call back. Thanks for everyone help. I will keep you folks informed. Wes

Thanks. Looks like that needs to be in conduit? Can it be direct burial?

No permit.