Recent content by Hacker-Pschorr

Figured better to bump this up than start a new thread. This is a follow-up to this thread: https://www.garagejournal.com/forum/showthread.php?t=422049 I ended up with a pair of these, from the same guy I bought the lift from...

I'm not sure how to describe what I'm thinking of doing. I have a 4-post lift and primary work on Porsche 928's. The 928 has a center lifting point between the rear wheels and another between the front wheels. This makes lifting the entire *** end or nose off the ground, then placing jack...

Awesome, thanks for the feedback, the HF unit it is & good advice on the ball valve on the end. I think the much more expensive unit at my friends shop came like that.

Long time lurker, might be my first thread. I searched & searched, couldn't find a thread on these products, which seems odd so I'm guessing I'm doing a bad job searching. I'm looking for input on these devices: Low end...

That will be the next one, the spot I posted above is going to be temporary. Using some leftover shelving parts, I found Lowes, HD, and Sams all sell individual pieces to the gorilla racks I already have. Sams and HD did not have a "ship to store" option and wanted to tack on $250 - $300...

My ceiling is 10' 6" and I'm installing a two post lift by cutting two holes in the ceiling sheet-rock. The posts will go into the attic with the cross bar going over the base of the joists. The primary car I work on is a Porsche 928, if my calculations are correct I'll be able to stand under...

Maybe not for the bench, but I need a lot of shelving in my other garage, the search is on!! That's what I did at my last place. I have a 10' section of counter top in storage that would be really nice. For this project I'm in a huge time crunch. I just want to open the box and assemble. I...

Wow - that opened up a whole new world of search options. Thank you! Well, I'm an idiot, in my other garage are two of these units (I installed them): http://www.homedepot.com/h_d1/N-5yc1v/R-202251082/h_d2/ProductDisplay?catalogId=10053#.USE7rmdOk4k The main reason why I liked that setup is...

Found this post using the Sears bench...... really like this idea but I don't have the equipment to make such a shelf. At least not one as nice of this: http://www.garagejournal.com/forum/showpost.php?p=2522580&postcount=12

Pardon the mess, I'm in the very early stages of getting my new garage figured out. I just purchased the 6' stainless toolbox / bench from Sam's club - $399. Assembly was fun, great box for the money. Here is what I'm thinking. I want this wall to be a workbench on the left with the...