Recent content by hammerlane

Old thread but did you ever purchase a flexible hose nozzle?? Found one for 16.29

You got one of the U-Tube heaters. Looks good. You say there is j-channel along the side of the vent?

Will wait to see your install pictures. Dont know how the flat portion of that vent would install "clean" with vinyl siding

I guess that is a condsideration. How long was your length of venting and how many elbows did you have in the run??

You can be flat against the wall if the fittings you use and where you use them allow it.

Here is one of the 40 footers. Thinks its 150K Btu

Will do with the photos

I have a 3-car garage, the heater is going to be for the single bay which is the "gathering" area. A neighbor has a forced air hanging unit and if the garage door gets opend---out goes the heat. I recently helped someone install 4 Detroit Radiant units on a job he was on. They were the double...

Or I may come into the garage on the other wall depending on placement of the burner.

for me it will be for NG. Im in the planning stages of getting a Detroit Radiant LS Series 10 foot Infrared Tube Heater for my garage. To get the NG into the attached garage, Im gonna punch thru the rim joist from the basement shown at the level of the green spot....but will be behind the...

I was able to obtain a close up photo of post #1's photo and Y2khawk hit the nail on the head. Thanks to all that offered suggestions.

Have no idea what picture you are referring to and no idea when you say "other clamps" what other clamps you mean. If you are referring to the picture in post #1, that is not unistrut

That looks more like what is in the 1st picture. Thanks.

I dont think it is unistrut. Never heard of a pipe stay but just looked it up and you may be correct. Thanks

Guess I could just use blocking behind the pipe like below but was wondering what those clamps/supports were in the above picture