Recent content by hanksgarage

Went in nicely and very tightly. Made sure I used alot of epoxy and used the coffee filter method. So far, so good. Torque'd down to 100ft lbs with no problems. Feels more secure. Will check the torque again to make sure.

Been using my max jax since the Costco sale and have had no major issues except a couple of the anchors have protruded out more than I’m comfortable with. wont completely come out (I tried) but it goes slightly past the lower plate thickness so I called GES and they sent me some of the epoxy...

found this forum while troubleshooting my MAX JACK lift and was relieved to find that someone else had the same problems i did with the install. thought it would be a quick in and out but looks like this place is resourceful for my interests so looks like i'll be sticking around. :beer:

gonna have to give GES tomorrow and get some of these :yikes:

i have the same exact issue ^ only 2 of my bolts pulled out with the cup trick. the rest came up a little less than an inch but still hold. was able to put the lift on top of the anchors and lock the existing 4 down to 100ft/lbs but still would like to find a way to fix the missing 1 on each side.